# version # Betaflight / STM32F7X2 (S7X2) 4.5.1 # start the command batch batch start # reset configuration to default settings defaults nosave board_name SPEEDYBEEF7V3 manufacturer_id SPBE # feature feature -AIRMODE feature OSD feature ESC_SENSOR # serial serial 0 131073 115200 57600 0 115200 serial 1 64 115200 57600 0 115200 serial 5 1024 115200 57600 0 115200 # aux aux 0 0 0 1700 2100 0 0 # ARM (AUX1) aux 1 1 1 1300 1700 0 0 # ANGLE MODE (AUX2 Mid) aux 2 28 2 1700 2100 0 0 # BEEPER (AUX3 High) aux 3 35 3 1700 2100 0 0 # FLIP OVER AFTER CRASH (AUX4 High) # master set gyro_lpf1_static_hz = 0 set gyro_lpf2_static_hz = 650 set dyn_notch_count = 1 set dyn_notch_q = 500 set dyn_notch_min_hz = 100 set dyn_notch_max_hz = 650 set dshot_bidir = ON set motor_pwm_protocol = DSHOT600 set motor_poles = 14 set dshot_idle_value = 550 set failsafe_procedure = DROP set vbat_min_cell_voltage = 330 set vbat_warning_cell_voltage = 350 set pid_process_denom = 2 profile 0 # profile 0 (6S 1300mAh Freestyle Tune) set dterm_lpf1_dyn_min_hz = 95 set dterm_lpf1_dyn_max_hz = 190 set dterm_lpf2_static_hz = 190 set p_pitch = 52 set i_pitch = 92 set d_pitch = 44 set f_pitch = 135 set p_roll = 49 set i_roll = 88 set d_roll = 41 set f_roll = 130 set p_yaw = 45 set i_yaw = 90 set f_yaw = 110 set d_min_roll = 36 set d_min_pitch = 39 set feedforward_averaging = 2_POINT set feedforward_smooth_factor = 45 set feedforward_jitter_factor = 7 rateprofile 0 # rateprofile 0 (Actual Rates - 720 deg/s Max) set rates_type = ACTUAL set roll_rc_rate = 14 set pitch_rc_rate = 14 set yaw_rc_rate = 14 set roll_expo = 54 set pitch_expo = 54 set yaw_expo = 50 set roll_srate = 72 set pitch_srate = 72 set yaw_srate = 68 # end the command batch batch end save