Differences

This shows you the differences between two versions of the page.

--- 3dprinting:printers:ender3v2:start [11/04/2026 15:20] – created Jon
+++ 3dprinting:printers:ender3v2:start [11/04/2026 15:21] (current) – [Creality Ender 5 Plus] Jon
@@ Line 1: / Line 1: @@
-qwert
+====== Creality Ender 3 V2 ======
+===== Machine Overview =====
+Document the current machine configuration here. Update this page whenever a major component is changed.
+===== Configuration Record =====
+^ Component ^ Installed part / setting ^ Date changed ^ Notes ^
+| Mainboard | | | |
+| Hotend | | | |
+| Extruder | | | |
+| Probe / leveling sensor | | | |
+| Bed surface | | | |
+| Fans | | | |
+| Motors / drivers | | | |
+| Firmware | | | |
+===== Useful Pages =====
+  * [[specifications|Specifications]]
+  * [[assembly|Assembly & Rebuild]]
+  * [[upgrades|Upgrades]]
+  * [[maintenance|Maintenance Log]]
+  * [[calibration|Calibration Log]]
+  * [[firmware|Firmware & Configuration]]
+  * [[troubleshooting|Troubleshooting]]
+===== Before Changing Hardware =====
+  - Photograph the original wiring and component placement.
+  - Record connector labels and polarity.
+  - Save the current firmware configuration.
+  - Change one major variable at a time.
+  - Test heaters, fans, endstops, and probe operation before printing.