N5JLD dot NET

What I do in my Spare Time

User Tools

Site Tools


ham:equipment:antennas:swr_logs

This is an old revision of the document!


Antenna SWR & Analyzer Log

Use this page to document baseline performance, tuning adjustments, and seasonal changes for shack and portable antennas.

Antenna & Test Setup

Parameter Details
Antenna Name / Type e.g., 40m–10m End-Fed Half-Wave (EFHW)
Test Date YYYY-MM-DD
Test Instrument e.g., NanoVNA-H4 / RigExpert AA-55 ZOOM / Rig Internal Meter
Calibration Plane At Shack Patch Panel / At Antenna Feedpoint
Feedline e.g., 75 ft LMR-400 + 6 ft RG-8X jumper
Balun / Unun / Choke e.g., 49:1 Toroid Unun + Common Mode Choke at feedpoint
Mounting Height & Config e.g., Inverted-V, Apex at 35 ft, Ends at 8 ft
Weather / Ground State e.g., Clear, dry soil, 65°F (Note: wet foliage shifts resonance)

Band-by-Band Sweep Summary

Record the lowest SWR point (resonant dip) and usable bandwidth (< 2.0:1 SWR) for each target band.

Band Freq Low (2:1) Resonant Dip Freq Min SWR Impedance (R ± jX) Freq High (2:1) Tuner Needed?
80m — — — — — —
40m 7.010 MHz 7.125 MHz 1.15:1 48 - j3 Ω 7.260 MHz No
30m — — — — — —
20m 14.000 MHz 14.180 MHz 1.22:1 54 + j8 Ω 14.350 MHz No
17m — — — — — —
15m 21.020 MHz 21.250 MHz 1.35:1 42 - j10 Ω 21.440 MHz No
12m — — — — — —
10m 28.050 MHz 28.400 MHz 1.40:1 62 + j12 Ω 28.850 MHz No

Tuning Notes & Adjustments

  • Baseline Observation: Initial sweep showed resonance slightly too low on 40m (7.040 MHz).
  • Physical Adjustment: Folded back 6 inches of wire at the far end insulator.
  • Result: Shifted 40m dip up to 7.125 MHz; 20m and 15m remained well within the voice/digital segments.
  • RFI / Common Mode Check: No RF feedback observed in shack at 100W FT8 on all tested bands.

Analyzer Captures & Touchstone Files

Upload screenshots from NanoVNA-Saver or AntScope via the DokuWiki Media Manager and link them below.

ham/equipment/antennas/swr_logs.1794759936.txt.gz · Last modified: by N5JLD